Autel MK808S Reset Nissan Note E12 IMMO after ECU Replacement

This Nissan Note E12 has just replaced the ECU, so there's a fault code on the car: "P1611 - ID IDSCORD, IMMU-ECM". Today I'm gonna use Autel MaxiCOM MK808S to reset its immobilizer to fix the error.

Click "NATS".

Turn ignition switch on, then press Yes.

After replacing operation >> Replace ECM(used part)

 

Set the vehicle to the following status, and then touch "Next".

- ignition switch or power switch: lock

- hazard switch: on(for preventing bcm from entering into can communication sleep mode)

- P(a/t) or neutral(m/t)

- battery voltage: more than 12.5v

- Steering: not in fully locked.

This procedure erase all registered key ids.

Therefore, all of the customer's keys should be obtained before starting this procedure. Press "Yes" to continue.

 

Operate according to the following procedure.

1. Press push-button ignition switch for 2s or more an turn ignition switch to the on position.

After performing this operation, the system automatically proceeds to initialization ecu.

 

Autel MK808S Perform Key Registration.

Operate according to the following procedures.

1. Press push-button ignition switch and turn ignition switch off.

2. Press push-button ignition switch once check that indicator on push-button ignition switch blinks.

3. Contact the back side of registered intelligent key to push-button ignition switch within 5 seconds.

Check that buzzer in combination meter sounds twice.

4. Check that turn ignition switch changes automatically to the on position and that security indicator blinks 5 times.

Check that push-button ignition switch turns on.

 

Test the new key. Its remote works and it can start the car.

Done.

Contact Info:

Email: sales@AutelShop.de

Wechat: +86-13429866263

Whatsapp: +86-13429866263

 

www.autelshop.de